#CONNECT CURA TO REPETIER SERVER FOR FREE#
#CONNECT CURA TO REPETIER SERVER UPDATE#
#CONNECT CURA TO REPETIER SERVER PRO#

Tick the checkbox saying “Port is visible, even if firmware is not running”. Now we need to adjust following parameters. In order to do this, please click on the small gear next the the printer name and select “Printer settings”. However we need to do some adjustments in the configuration.

#CONNECT CURA TO REPETIER SERVER PRO#

Your printer is now configured in your Repetier Server Pro print server. This is the fan cooling the filament, not the one cooling the hotend! For double check, use the screenshot below.įor the last step, please set “Fan” to 1.

#CONNECT CURA TO REPETIER SERVER UPDATE#

The extruder and heatbed settings should be correct, so no need to update this section. In the next step we add the size of the printer. If not, please see the screenshot below as reference. The config wizzard should now be able to load all parameters of your printer from its firmware. Make sure again that you’ve connected & powered up your printer at this step! If so, start the configuration wizzard by clicking the “Create new Printer” button.įirst of all, give it a proper name. You should be able now to see the Repetier Server Dashboard. If you do not know the IP address, use the name or check your router. You either can type in the name, or the IP address. When ready, go to your computer and visit Repetier Server Pro. For setup, I recommend you to connect a cable. That’s quite normal, so don’t worry.ĭepending on your network, please connect the Raspberry Pi either via wire or wifi. During booting up, the printer might restart a few times. When all preparation is done, connect your Prusa i3 printer to a free USB port on your Respberry Pi. Repetier Server Pro Configure your Prusa i3 If you are looking for an enclosure, you can download the printable files from thingiverse. If you’ve decided to purchase a touch screen, please follow the instructions of your touch screen and connect it to your Raspberry Pi. Make sure that you have nothing important stored on your sd card! The flash process will wipe out all data on your card! Flashing done successfully Assemble your touch screen Select now your target sd card and start with the “Flash!” button. Once downloaded, please run the application and select the previously downloaded disk image.

#CONNECT CURA TO REPETIER SERVER FOR FREE#

You can download it for free from this link. There are several ways to do this, but the easiest might be to use the tool Etcher for this job. Thank you for supporting us!) Prepare your Raspberry Piįirst of all you need to download the disk image for the Raspberry Pi from the Repetier Server homepage. *(affiliate / partner link, we get a commission for each purchase. Have you seen the brand new Prusa XL already? Check it out here*. Looking for a good 3D printer or high quality filaments? Check out the brand new prusa store*! 7″ Raspberry Pi Touchscreen (official )Ī touchscreen is not mandatory to run the Repetier Server Pro, however it allows you a better control directly at your printer.microSD card (recommended is at least 32 GB).Raspberry Pi 3 B+ (Version 2 might work as well).In order to connect your Prusa i3 MK3 3D printer to Repetier Server Pro you need following components (soft- & hardware) Mandatory

Connect cura to repetier server